|
Derek Bolton | Member since October 2009 | Posted 12 years ago | 0 |
||
Hi John, The obvious one which I have mentioned before is the ability to split the route using something like a waypoint so I could use say a 6 mile route as the 1st mile easy run, miles 2 - 5 tempo run, and finally mile 6 easy, and then the ability to segregate these in the performance figures, because at the moment the whole run is agregated. I know the multi run does that but you physically have to chop the route up and as it is I have over 200 routes listed on my route and it gets a bit confusing if I have to further segregate them. |
|||||
Dave Johnson | Member since September 2010 | Posted 12 years ago | 0 |
||
Ashley - Yeah, that would be cool, but I suspect asking too much! You're probably aware of this, but you can select 'Snap to Roads' which allows you to click anywhere and it will select the nearest point on a road and draw the shortest route along roads to it. It doesn't work with cycle paths, though, also doesn't work when inserting points, and of course you can't tell it how long to make the loop. Lauren - Choose 'Insert', then click the last point before the bit you want to add in. This adds a point midway to the next one. Then move the new point to where you want it and repeat until done. Have I got those about right, John? |
|||||
Ashley Banyard | Member since December 2006 | Posted 12 years ago | 0 |
||
This may be impossible but can you make it so that the measurer tool will draw a loop for you? I mean if you specify a start and end point, can you programme the tool to find route of different lengths using roads and or cycle paths around your input points?? That would be ace!
|
|||||